Listen to the pond.Feed only what the shrimp eat.

AquaByte is a smart shrimp feeder. Hydrophones hear when shrimp are feeding, a servo spreader drops just enough feed, and water conditions are tracked in real time.

A simulated pond. While shrimp feed, the hydrophone picks up sharp clicks and the feeder drops feed. When they fill up, the clicks fade and the feeder stops.

Feeding by the clock wastes feed and fouls the water

Shrimp don't eat the same amount every hour. A timer, or a worker judging by eye, keeps dropping feed after they are full. What is left uneaten sinks, breaks down and spoils the pond.

Overfeeding
Too much feed leads to a 40% increase in ammonia in the water.
Wasted feed
Up to 30% of the feed you pay for goes uneaten.
Manual work
Someone has to be at the pond for every feeding and guess how much to give.
Disease risk
Poor water quality stresses shrimp and gives disease an opening.

A feeder that listens before it drops anything

AquaByte at a shrimp pond Cross-section of a pond. A hydrophone hangs in the water near shrimp and sends its signal to a controller on the bank. A feeder above the controller scatters pellets onto the water, and Wi-Fi sends data out. 1 2 3 4
  1. Listen

    A hydrophone in the water picks up the sound of shrimp feeding.

  2. Decide

    A microcontroller processes the signal in real time and checks it about every 2 seconds.

  3. Dispense

    A servo-controlled spreader scatters feed evenly, within ±5% of the amount it is told to deliver.

  4. Report

    Feeding and water data goes out over Wi-Fi to analytics, so you can see what happened in the pond.

What testing has shown so far

AquaByte has been validated through simulation and real-time sensor testing.

±5%

Feed delivery accuracy

How close each dose lands to the amount the feeder was asked to drop.

~2 s

Sensor monitoring

The signal is checked about every 2 seconds, so the feeder can stop soon after the shrimp do.

98%

Data transmission success

Share of readings that make it from the pond over Wi-Fi.

Try it: hungry shrimp, full shrimp

This is a simulation with made-up numbers, not field data. Drag the slider to change how hungry the shrimp are, or run a full feeding session. The timer feeder drops the same amount every minute. AquaByte follows the signal.

Hungry

Timer feeder

Drops 10 g every minute, whatever the shrimp are doing.

Dropped
0 g
Eaten
0 g
Wasted
0 g

AquaByte

Drops feed in step with the signal, and stops when the clicks stop.

Dropped
0 g
Eaten
0 g
Wasted
0 g

One second on screen is one simulated minute. AquaByte's dose can be off by up to 5%, as in testing.

Put a number on wasted feed

Enter your own figures to see how much feed and money goes uneaten in one crop cycle. This is an estimate, not a promise. Your savings depend on your farm, your feed and your shrimp.

30%
Feed wasted per crop cycle
₹8,64,000

10,800 kg of feed

Up to 30% of feed can go to waste without feeding detection. Change the slider to match your farm.

Less waste in the water and on the balance sheet

  • Feed wastage down by 30%Feed goes to shrimp, not to the pond bottom.
  • Better water qualityLess uneaten feed breaking down in the water.
  • Healthier shrimpCleaner water means less stress and less disease risk.
  • Lower running costsLess feed bought and less manual feeding work.

Built for

  • Large shrimp farms of 10 hectares or more
  • High-tech aquaculture parks
  • Government aquaculture projects
  • NGOs

UN Sustainable Development Goals it supports

  • 3Good Health and Well-being
  • 6Clean Water and Sanitation
  • 12Responsible Consumption and Production
  • 13Climate Action

Twelve months from prototype to production

  1. Months 1–2Build the MVP
  2. Months 3–4Validate the product
  3. Months 5–6Prove market fit
  4. Months 7–8Get certified
  5. Months 9–11Pilot production
  6. Months 11–12Scale up manufacturing

The team

  • Dineshvaran SDesign Engineer
  • Krisnan KMechanical Engineer
  • Brathikan VMSimulation Expert
  • Theneeshwaran MEmbedded Engineer